ASE G1 Test QUESTIONS WITH COMPLETE 100% VERIFIED SOLUTIONS 2024/2025, Exams of Physics

Download ASE G1 Test QUESTIONS WITH COMPLETE 100% VERIFIED SOLUTIONS 2024/2025 and more Exams Physics in PDF only on Docsity! ASE G1 Test QUESTIONS WITH COMPLETE 100% VERIFIED SOLUTIONS 2024/2025 Technician A says that when pressure testing a radiator cap, a special adapter is needed. Technician B says the best way to check thermostat operation is while it is in the engine. Who is right? Tech A A technician is checking resistance in an engine's spark plug wires using an ohmmeter. A general rule is to replace a wire if resistance is over: 30,000 ohms Technician A says that in an ignition system, the voltage supplied to the coil during starting is battery voltage. Technician B says the coil uses electromagnetic induction to create high voltage. Who is right? Both techs A front wheel drive vehicle with an automatic transaxle has excessive vibration. Technician A says that the vibration could be caused by worn engine/transaxle mounts. Technician B says that the vibration could be caused by a misaligned engine/transaxle subframe. Who is right? Both techs A technician suspects that a faulty camshaft sensor causes a driveability complaint. The sensor is equipped with a three-wire connector. What type of sensor is this? a Hall effect type All of the following can cause a problem in the Hydro-boost system EXCEPT: A. loose power steering pump belt B. leaking power steering hoses C. low power steering pump pressure D. leaking check valve D Technician A says that if a wire is getting too hot, it's a sign of higher-than-normal current flowing through. Technician B says the wire would heat up if some of the individual strands are broken inside the wire insulation. Who is right? Both techs Technician A says electrical connectors can be disconnected with the ignition switch ON, as long as the technician is using a ground strap. Technician B says when welding on a vehicle, the technician needs to use a static wrist strap. Who is right? Neither Technician A says the thermostat maintains maximum engine operating temperature. Technician B says if the engine continuously runs hot, install a cooler thermostat. Who is right? Neither A vehicle equipped with a MacPherson strut suspension is in the repair shop for new tires and an alignment. The technician noticed that the vehicle has some play in the lift-side inner tie-rod. What should the technician tell the customer? A. It is not a problem that will affect alignment. B. He can align the front end, but the tie-rod should be replaced soon C. The inner tie-rod needs to be replaced before an alignment can be performed D. He can set the vehicle alignment to compensate for the play in the inner tie-rod C. An engine is losing coolant, yet has no external leaks. Technician A says to run the engine and see if there is white smoke out of the exhaust. Technician B says to find out if the engine's emission system uses a catalytic converter before running the test above. Who is right? both LED bulbs can remain effective for up to how long depending on the size of the bulb and the conditions to which the bulb is exposed? 15000 hours All of the following should be performed during a preliminary transmission inspection EXCEPT: A. check transmission fluid level B. visually check wiring and electrical connections C. check the condition of the filter D. check for fluid leaks C A smeary film on the windshield is an indication of: A. evaporator core leak B. water valve leak C. heater core leak D. restricted drain hose C Technician A says that all power should be removed from a circuit before testing the circuit with an ammeter. Technician B says that all power should be removed from a circuit before testing the circuit with an ohmmeter. Who is right? Both Technician A says maintenance-free batteries have a built-in hydrometer which can give you an indication of the battery's overall condition. Technician B says since a maintenance-free battery is sealed, it should be checked using a test light. Who is right? Neither Technician A says that lubricant can be used to help seat a tire on a wheel rim. Technician B says that if necessary, it is OK to exceed the maximum tire pressure rating to seat the bead, as long as the pressure is reduced immediately afterward. Who is right? Tech A Technician A says that all vehicles with strut-type front suspension require that the strut is removed to replace the front coil springs. Technician B says that the coil spring should be compressed before removal from an SLA front suspension. Who is right? B Which of the following causes for ball joint replacement could also require steering knuckle replacement? A. torn dust boot B. worn ball and socket C. wear indicator below surface D. broken ball stud D All of the following are true statements regarding tapered wheel bearings EXCEPT: A. the bearings and outer races must be replaced as an assembly B. they must be adjusted after installation C. Used bearings must be reinstalled on their original races D. They are mostly used on drive axles D Technician A says an indirect measurement Tire Pressure Monitoring System uses wheel speed sensors to measure tire pressure. Technician B says a direct measurement TPMS uses tire pressure sensor to measure tire pressure. Who is right? Tech B Tire cupping is MOST likely caused by which of the following? A. worn shock absorbers B. wheel imbalance C. loose tie-rod ends D. all of the above D Tech A says a noisy alternator could be caused by a bad diode. Tech B says a noisy alternator could be caused by a worn bearing. Who is right? both Which setting on a digital multimeter is used to check resistance? A. millivolt B. milliamp C. ohms D. voltage C Voltage drop tests are used to locate: A. low resistance B. shorts C. opens D. high resistance D When testing computer-controlled systems, a Digital Multimeter should be used with an output impedance of at least: A. 10k ohms B. 100k ohms C. 1 Megaohm D. 10 Mega Ohm D Tech A says a Digital Graphing Multimeter can be used to view electronic wave forms. Tech B says GMMs can be used to view vehicle-specifice information displayed on screen. Who is right? Both techs A vehicle has experienced a charging problem. A tech inspected the charging system, found loose alternator mounting bolts, and tightened them. Afterwards, the vehicle performed OK. Tech A says the problem might have been a slipping belt. Tech B says the problem might have been poor grounding of the alternator. Who is right? Both techs A horn is inoperative. Tech A says in order to repair the horn switch; the Supplemental Restraint System should be disabled. Tech B says to check for voltage at the relay. Who is right? Both techs A wiper motor is not operating. However, when the linkage is disconnected, the motor operates OK. Tech A says the problem could be a bad relay. tech B says the problem is MOST likely binding linkage. Who is right? Tech B Tech A says that a test light is a good diagnostic tool for testing general lighting circuits and grounds, but should not be used on solid-state electronic circuits. Tech B says that a self- powered test light is a good diagnostic tool for testing voltage sources. Who is right? Tech A A windshield washer system is being checked. Fluid is spraying from the nozzle on the passenger side, but not on the driver's side. Of the following answers, what is the most likely cause? A. blown fuse B. no voltage at the pump C. low fluid level D. kinked or blocked hose D Tech A says that if a wire is getting too hot, it is a sign of higher-than-normal current flowing through the wire. Tech B says the wire would heat up if some of the individual strands were broken inside the wire insulation. Who is right? Both techs Starting system voltage drop tests are used to locate: A. low resistance B. shorts C. opens D. high resistance D Cooling system pressure is maintained by the use of the: A. fan clutch B. water pump C. thermostat D. radiator cap D Tech A says that when checking charging system voltage output, all electrical accessories should be on. Tech B says when checking charging system voltage output, the reading should be around 18 volts. Who is right? Neither Tech A says that pink colored transmission fluid is evidence of fluid aeration. Tech B says that pink colored transmission fluid is caused by coolant contamination. Who is right? Tech B The driver notices a clear fluid dripping from the underside of his vehicle with the engine running and the A/C on. Tech A says this is refrigerant over flow. Tech B says the dripping will stop after the A/C system is shut off. Who is right?