Military Vehicle Maintenance and Operations Guide, Exams of Advanced Education

Download Military Vehicle Maintenance and Operations Guide and more Exams Advanced Education in PDF only on Docsity!

88M Study guide with correct Answers

Which of the following is not a guideline when encountering a suspected IED - Answers

• Color What component sends fuel to the engine on a M915A3/A5 - Answers - Fuel Pump What is the safest way to connect the air hoses and light cables when coupling a tractor to a semi-trailer - Answers - Farthest to closest Which is not a major purpose of the DA Form 5988-E - Answers - Motor vehicle use What is the ground guide signaling by extending their arm sideways, slightly above horizontal, palm to the front and waving the arm to and from the head several times - Answers - Attention What DD Form would the operator annotate oil usage - Answers - 1970 What is the difference between a DA Form 5987 and a DD Form 1970 - Answers - The 5987 is electronic and the 1970 is manual If only one ground guide is available, where should they be posted based on the driver's point of view - Answers - 10 yards diagonally to the left of the front bumper When would an operator put the date in the "Fault Description" block in the Maintenance Faults section of the DA Form 5988-E - Answers - If no new faults are found What maintains the battery charge of a M1120A4 - Answers - 24 VDC alternator Where is the C2 vehicle located within the convoy - Answers - It's up to the convoy commander Which is an advantage to using the Open Column Convoy - Answers - Cargo moves faster Which statement is false pertaining to Call Signs - Answers - Spells out words or names on a radio net Refer to the ______________ to determine if a vehicle's cube limitations have been exceeded before tying down a load - Answers - Vehicle data plafe

What Form is given to any person involved in an accident involving a DoD vehicle - Answers - DD Form 518 Set the M1120A4 hydraulic selector switch to _______________ for over the road travel if manual load operation was used - Answers - MAN TRANS When will the operator place their initials in the Maintenance Faults section of the DA Form 5988-E - Answers - No faults are discovered after completing the "After" inspection The Traction Control Switch in the M1120A4 should be in what position for normal drive mode - Answers - Center What is the ground guide instructing the vehicle operator to do when facing the vehicle with their hands raised to shoulder level, palms to the front and moving their hands forward and backward - Answers - Move in reverse What is the maximum towed speed when recovering a M1120A4 - Answers - 15 mph The operator has to__________ in order to release the air brakes on the M915A3/A5 - Answers - push in the Yellow knob How far down should the operator lower the landing gear when uncoupling a tractor- trailer - Answers - Until space between the fifth wheel and the trailer is present When coupling to a semi-trailer, all of the following should be checked during a 360 walk around inspection except ________________. - Answers - ensure the fifth wheel ramps are slightly above the pick-up ramps What action should the operator take if the M1120A4 transmission range selector flashes current gear selection while operating the vehicle - Answers - Move to a safe place for maintenance Place the chock block_______ during coupling operations - Answers - Behind the intermediate right tire The SITUATION paragraph of a convoy briefing contains all of the following except _________________. - Answers - vehicle spacing Why must the M1120A4 be stopped before the transfer case can be shifted between ranges - Answers - Gears are not synchronized A critical point symbol on a strip map is used to identify what object or feature - Answers

• An overpass What gear is shown in the M1120A4 digital display window when the engine brake is activated while decelerating - Answers - 2

How many chains are needed to tie-down a payload vehicle of 11,000 lbs - Answers - 4 Where is the center of gravity mark on the M1077 located - Answers - 106 inches from the front edge of the flatrack What does a broken line indicate on the diagram portion of the Lubrication Order - Answers - The same components are located on each side of the vehicle Do all of the following except _________________ when positioning a semi-trailer to a loading dock - Answers - Pull forward 100 yards and stop The M915A3 fifth wheel is used to transport which of the following trailers - Answers - M What two forms notify the operator when the next vehicle service is due - Answers - DA Form 5987 and DA Form 5988-E What is a purpose of the DA Form 5987 - Answers - Record fuel usage If using more than one ground guide to back a vehicle, which ground guide is responsible for signaling the vehicle operator - Answers - The front ground guide What size chains should be used when securing a vehicle weighing 18,500 lbs - Answers - 1/2 inch In reference to METT-TC, which is not a part of the Army acronym OCOKA - Answers - Key leadership What is represented by a broken line in section IV of the SF 91 - Answers - Path of the vehicle after the accident When traveling in a convoy, which of the following would not be a strong indicator of an IED placement - Answers - Increased civilian traffic The fully loaded M915A3 can maintain a maximum speed of Class I roads - Answers - 65 mph All of the following are definitions of a strip map except _____________ - Answers - must be drawn to scale What is a responsibility of a radio operator - Answers - Use phonetic alphabet How many forward gears does the M1120A4 transmission have - Answers - Five (5)

What PROWORD should a receiver use if they did not understand a radio message and need it repeated - Answers - Say again What component is not part of the M1120A4 Air Intake System - Answers - Air compressor Serials within the convoy should be separated by ______ minutes - Answers - 15 What component provides fluid power to the Load Handling System - Answers - Hydraulic pump Which paragraph of the OPORD (Operation Order) specifies Radio Call Signs - Answers - Command and signal