MA Hoisting License Test Exam With 100% Correct Answers 2024, Exams of Advanced Education

Download MA Hoisting License Test Exam With 100% Correct Answers 2024 and more Exams Advanced Education in PDF only on Docsity! MA Hoisting License Test Exam With 100% Correct Answers 2024 What is the most important single factor to the safe operation of the forklifts? - Correct Answer-THE OPERATOR Many accidents happen because the operator does which of the following? - Correct Answer-a) uses a forklift with a known defect b) travels an unsafe route c) carries unsafe loads d) uses unsafe operating techniques When is it safe to operate the forklift from a place other than the operator's seat? - Correct Answer-NEVER Workers and bystanders within the danger area of the forklift should be considered the responsibility of? - Correct Answer- THE OPERATOR Which of the following are essential for safe operation? - Correct Answer-a) smooth starts b) smooth stops c) smooth turns The operator "feathers" the controls when he wants to? - Correct Answer-MOVE THE LOAD SLOWLY If you find a fault or suspect an unsafe condition while inspecting or operating a forklift you should? - Correct Answer-TELL YOUR SUPERVISOR If bystanders or a fellow worker are in danger from a raised load, you should? - Correct Answer-SOUND YOUR HORN OR ASK THEM TO MOVE Which of the following affect forklift safety? - Correct Answer- a) Leverage b) Center of gravity c) Momentum The pivot point of a forklift is? - Correct Answer-THE FRONT AXLE WHEEL STEERING, FRONT WHEELS FIXED STRAIGHT AHEAD, REAR WHEELS USED FOR STEERING Using a short turning radius when traveling at high speeds can cause overturning due to? - Correct Answer-THE FORCES OF MOMENTUM When is it permissible to carry riders while you are operating a forklift? - Correct Answer-NEVER If a forklift tips forward ... - Correct Answer-STEERING CONTROL IS LOST When traveling up or down a ramp, you can place more traction on the front drive wheels of an unloaded forklift if the forks are? - Correct Answer-KEPT POINTING DOWNHILL Rear-wheel steering used by many forklifts? - Correct Answer- a) Cause both ends of the forklift to swing around when turned b) Can cause the load to fall off the forks if the turn is made too fast c) Causes them to act differently from cars, which have front wheel steering Do not start a forklift unless. - Correct Answer-a) The controls are in neutral b) The hand brake is set c) You are sitting in the operator's seat When may reverse gears be used to slow or stop a forklift traveling forward? - Correct Answer-NEVER What things determine how fast a hydraulic system moves? - Correct Answer-a) The distance the controls are moved d) The engine speed Jerky movements can be avoided if the operator. - Correct Answer-FEATHERS THE CONTROLS If the hydraulic system develops a leak during operation, you should. - Correct Answer-a) Lower the load b) Shut off the engine c) Notify the supervisor Job site conditions are? - Correct Answer-IMPORTANT SINCE THEY DETERMINE THE SAFE SPEED AT WHICH A FORKLIFT CAN OPERATE If the load being carried obstructs vision, the operator should? - Correct Answer-DRIVE IN REVERSE When crossing railroad tracks or other similar rough sections with a loaded forklift you should? - Correct Answer-CROSS THEM DIAGONALLY When traveling down a hill or slope you should? - Correct Answer-SAVE THE BRAKES BY USING THE SAME GEAR TO GO DOWN HILL AS WOULD BE USED TO GO UP IT When traveling on a slope it is necessary to? - Correct Answer- a) Approach it straight b) Do not turn on the hill c) Do not travel crossways The load will have maximum stability if... - Correct Answer- THE FORK TIPS ARE INSERTED UNTIL IT IS AGAINST THE BACKREST Carrying the load on the tips of the forks can? - Correct Answer-a) Act as an unwanted counterweight in front b) Create an unstable load condition c) Result in the load's falling off the forks An over-capacity load can be lifted if the load is? - Correct Answer-NONE OF THE ABOVE True or False...Carrying a forklift load low INCREASES EFFECTS OF JOLTS FROM ROUGH TERRAIN? - Correct Answer-False Driving in reverse requires the operator to use a slower speed because? - Correct Answer-MORE REACTION TIME IS NEEDED TO REACH THE CONTROLS WHEN THE DRIVER IS FACING THE OPPOSITE DIRECTION The stability of an unloaded forklift is: - Correct Answer-JUST AS IMPORTANT AS THAT OF ONE CARRYING A LOAD When operating a forklift on a job site where there are other vehicles: - Correct Answer-a) Keep to the right when traveling in areas with two way traffic b) Stay 20 feet behind a vehicle in front of you When approaching the location where a load will be placed you should? - Correct Answer-PROCEED SLOWLY Forklifts that are equipped with hydraulic frame leveling or lift mechanism tilting systems: - Correct Answer-SHOULD BE ADJUSTED BEFORE THE LOAD IS LIFTED Ramming the hydraulic lift cylinder's to the end of their stokes can... - Correct Answer-RESULT IN JOLTS WHICH ARE TRANSFERRED TO THE LOAD If it is necessary for you to restack the load, you should? - Correct Answer-a) Set the brake before getting off the forklift b) Turn off the engine One of the most potentially dangerous times you will encounter is: - Correct Answer-WHEN THE LOAD IS FULLY EXTENDED OVERHEAD Before raising a load: - Correct Answer-a) The brakes should be set b) The lifting mechanism should be vertical c) The forklift should be as level as possible Outriggers, or stabilizer's, should - Correct Answer-b) Should be set before the load is lifted c) Should be used only to give extra stability If a stacked load begins to lean or shift while being raised: - Correct Answer-LOWER THE LOAD AND RESTACK IT While a load is being lifted, it should be: - Correct Answer- TILTED SLIGHTLY BACKWARDS Before you withdraw the forks from a load that has just been placed you should? - Correct Answer-THEY SHOULD BE NEARLY PARALLEL WITH THE GROUND b) Fuel c) Hydraulic d) Brake One of the main safety reasons for checking the proper tire inflation is? - Correct Answer-a) To assure that the forklift will have stability it is designed for b) To make sure it has proper traction c) To make sure steering easier If the gauges do not register normal while the forklift is being operated: - Correct Answer-a) Turn off the engine b) Notify your supervisor The hydraulic system should be checked by: - Correct Answer- OPERATING EACH HYDRAULIC ACTION THROUGH ITS FULL CYCLE When you are operating a forklift, which of the following signs indicate imminent danger? - Correct Answer-a) Faulty brakes b) Faulty steering c) Faulty hydraulic mechanism When using jumper cables to start a forklift with a low battery: - Correct Answer-ALWAYS MAKE THE FINAL CONNECTION TO THE FRAME OF THE FORKLIFT WITH THE LOW BATTERY Which of the following statements is not true about the jumper cable safety? - Correct Answer-ALWAYS MAKE THE FIRST CONNECTION TO THE LOW BATTERY Fork trucks in a warehouse environment should? - Correct Answer-STAY TO THE RIGHT AND 20 FEET BACK FROM ANOTHER FORK TRUCK TRAVELING IN YOUR DIRECTION.