Apprentice Lineman 1-3, Exams of Electrical Engineering

Apprentice Lineman 1-3Apprentice Lineman 1-3

Typology: Exams

2025/2026

Available from 06/16/2026

pass-withpolly7
pass-withpolly7 🇺🇸

27K documents

1 / 5

Toggle sidebar

This page cannot be seen from the preview

Don't miss anything!

bg1
Apprentice Lineman 1-3
$144,246 -✓✓On a line construction job, an electrical contractor spent $85.242
on materials. $53,616 on labor and S5.388 on overhead. What was the total cost of
this job?
16 3/4 -✓✓Rewrite the following fraction as a mixed number in its lowest term.
67/4
$765 -✓✓Copper wire costs $1,020 per ton. How much would 3/4 of a ton of
wire cost?
34 -✓✓Multiply 7 1/4 X 4 3/5 (Round to nearest whole
number.
3 1/4 -✓✓Convert the following decimal number to a fraction. 3.250
decimal point -✓✓When adding. subtracting, multiplying, or dividing decimals,
the most important thing to keep track of is the ________.
8.70kV -✓✓A fault on a 12.8-kilovolt line caused the voltage to dip 0.68 of its
original value. What was the voltage at the time of the fault. expressed in kilovolts
and rounded to the nearest hundredth?
100 -✓✓A percent is a special ratio that compares a number to _______ using the
symbol %.
34% -✓✓An Electrical Worker's wages increases from $18.48 to $24.78 per
hour. What is the percentage of the increase?
21 -✓✓4.20 is 20% of _______
electron -✓✓The part of an atom that has a negative charge is called the
___________
magnetism -✓✓What is the PRIMARY source of electrical power?
pf3
pf4
pf5

Partial preview of the text

Download Apprentice Lineman 1-3 and more Exams Electrical Engineering in PDF only on Docsity!

Apprentice Lineman 1- 3

‣ $144,246 - ✓✓On a line construction job, an electrical contractor spent $85. on materials. $53,616 on labor and S5.388 on overhead. What was the total cost of this job? ‣ 16 3/ 4 - ✓✓Rewrite the following fraction as a mixed number in its lowest term. 67/ ‣ $765 - ✓✓Copper wire costs $1,020 per ton. How much would 3/4 of a ton of wire cost? ‣ 34 - ✓✓Multiply 7 1/4 X 4 3/5 (Round to nearest whole number. ‣ 3 1/4 - ✓✓Convert the following decimal number to a fraction. 3. ‣ decimal point - ✓✓When adding. subtracting, multiplying, or dividing decimals, the most important thing to keep track of is the ________. ‣ 8.70kV - ✓✓A fault on a 12.8-kilovolt line caused the voltage to dip 0.68 of its original value. What was the voltage at the time of the fault. expressed in kilovolts and rounded to the nearest hundredth? ‣ 100 - ✓✓A percent is a special ratio that compares a number to _______ using the symbol %. ‣ 34% - ✓✓An Electrical Worker's wages increases from $18.48 to $24.78 per hour. What is the percentage of the increase? ‣ 21 - ✓✓4.20 is 20% of _______ ‣ electron - ✓✓The part of an atom that has a negative charge is called the

‣ magnetism - ✓✓What is the PRIMARY source of electrical power?

‣ protons - ✓✓The atomic number of an element is the same as the number of _______ in the nucleus. ‣ conductor - ✓✓Resistance increases when a(n) ______ is heated. ‣ a pole of an energy source with an excess of electrons to a pole with a deficiency of electrons - ✓✓The flow of electrons in a circuit is always from ______ ‣ outer shell - ✓✓Electrical current is produced when electrons in the ________ knock electrons from another atom out of orbit. ‣ E - ✓✓Voltage is represented by the letter ______ when using Ohm's Law calculations. ‣ wattage - ✓✓power is measured in ________ ‣ voltage - ✓✓The force that pushes the electrons through a conductor and is often referred to as electrical pressure is called __________. ‣ 5,280' - ✓✓One mile equals ________ ‣ 1,000 - ✓✓When the prefix kilo is used, the number is multiplied by

‣ SI metric - ✓✓The system of measurement that has been declared by the U.S. Congress as the preferred method is the _______ system. ‣ thermocouple - ✓✓What type of device uses the heating of two dissimilar metals to produce an electrical potential? ‣ neon - ✓✓What type of gas will give off light when current passes through it? ‣ joining two dissimilar metals together at a junction and applying heat - ✓✓The process of __________, is known as the thermoelectricity process. ‣ 45 - 55% - ✓✓A rope's strength is reduced by approximately _______ when knots are tied in fiber rope.

‣ owner's manual - ✓✓Information covering specific safety, service. and operating information for a piece of powered equipment is normally found in the _______. ‣ warning - ✓✓Which of the following terms indicates a potentially hazardous situation? ‣ employee in charge of the work - ✓✓When an individual arrives at the job site, OSHA requires that the _______ hold a job briefing before the start of each job. ‣ on the right hand side of the road facing the direction of traffic flow - ✓✓If you must park a digger derrick on a roadway, you should park ________. ‣ while a load is suspended - ✓✓The operator of a digger derrick may not leave his position at the controls _________. ‣ I., II. III. and IV. - ✓✓An MSDS must include which of the following? I. Address of the chemical manufacturer Il. Importer or other responsible party who can provide additional information III. Name of the chemical manufacturer IV. Telephone number of the chemical manufacturer V. Phone number of local first responders ‣ carcinogenicity - ✓✓An example of a health hazard related to chemical use is ________. ‣ Hazardous Communication - ✓✓The Occupational Safety and Health Administration (OSHA) issued the _______ Standard to help control chemical exposure on the job. ‣ Class E - ✓✓What class of hard hat is worn extensively by Electrical Workers? ‣ 6 months - ✓✓Rubber insulated gloves should have a test date that is not older than _________. ‣ 600V - ✓✓Electrical hazard shoes offer protection against shock hazards from contact with open circuits of______ or less under dry conditions.