NACE CIP 1 CBT Exam Practice Questions |Latest Update| Already Graded A+ (just released), Exams of Public Health

Download NACE CIP 1 CBT Exam Practice Questions |Latest Update| Already Graded A+ (just released) and more Exams Public Health in PDF only on Docsity!

Name: Score: 20 Multiple choice questions Term lof 20 Conventional spray us good choice when: O High quality finishes are required. O Low cost finishes are preferred. O Minimal surface preparation is required. O Rapid application is necessary. Term 2 of 20 Which profile comparators are referenced by ISO 8503? O Oil O Cissing O Pen O Grit and Shot Term 3 of 20 Check abrasive blast pressure with a: O Needle Pressure Gauge O Nozzle Aperature Gauge O Replica Tape O Nozzle Aperture Gauge Term 4 of 20 ISO SA 3 is directly equivalent to: © NACE No.4/SSPC SP 12 O NACE No.2/SSPC SP 10 O NACE No1/SSPC SP 5 © NACE No.3/SSPC SP 11 Term 5 of 20 High viscosity due to low temperature should be corrected by? O Non drying and non curing. O Uneven DFT, Dry Spray and Overspray. O Adding extra thinner. O Lifting with a dull putty knife. Term 6 of 20 You are on a project where Testex tape is specified to determine surface profile by ASTM D4417 Method C. Which of the following is likely to cause reading errors? O Dust on the surface and Using an incorrect grade of tape. O Temperature variations and Using a magnetic gauge. O Moisture on the surface and Using a digital caliper. O Oil residue on the surface and Using a laser scanner. Term 10 of 20 SSPC SP 1 identifies the use of: oO Only non-metallic materials. O Specific types of coatings only. O Awide variety of materials. O Alimited range of materials. Term ll of 20 ISO SA 2 is defined as: O AWide Variety Of Materials. O Light Blast Cleaning O Applied In Very Thin Films. O Thorough Blast Cleaning Term 12 of 20 Which coating component forms a stable film that retains its characterstic properties? O Binder/Resin O Electrolyte O Solvent/thinner O Pigment Term 13 of 20 NACE Level 1 Inspectors have been trained to perform: O Advanced material testing and engineering. O Visual inspection and non destructive testing. O Mechanical testing and structural evaluation. O Chemical analysis and destructive testing. Term 14 of 20 SSPC Technology Guide No. 12 states coating inspection requires a minimum of which of the following? © 100 foot candles (1076 lumens) O 75 foot candles (807 lumens) © 50 foot candles (538 lumens) © 25 foot candles (269 lumens) Term 15 of 20 The contractor has open choice on actions: O May O Shall Not O Shalt O Must Term 19 of 20 The formation of small bowl shaped depressions in the coating find cause by air trapped in the coating is called? O Mud Cracking O Blooming O Cissing O Cratering Term When applying coatings, generally high relative humidity it: O has no affect on solvent evaporation O slows solvent evaporation O has no effect o solvent evaporation O accelerates solvent evaporation 20 of 20