





Study with the several resources on Docsity
Earn points by helping other students or get them with a premium plan
Prepare for your exams
Study with the several resources on Docsity
Earn points to download
Earn points by helping other students or get them with a premium plan
A comprehensive overview of the national electrical code (nec), which is the standard for electrical installations in the united states. It covers a wide range of topics, including continuous load requirements, adjustment factors for current-carrying conductors, emt sizing, overcurrent protection, conduit fastening, ballast compartment temperature ratings, hazardous location classifications, voltage drop calculations, equipment grounding conductor sizing, motor branch circuit protection, and more. Likely intended for electrical professionals, such as electricians, engineers, and inspectors, who need a thorough understanding of the nec to ensure safe and compliant electrical installations. The level of detail and technical nature of the content suggest that this document would be most useful as study notes, lecture notes, or a reference guide for those preparing for electrical licensing exams or working on complex electrical projects.
Typology: Exams
1 / 9
This page cannot be seen from the preview
Don't miss anything!






What table sizes bonding jumpers for for AC systems? - answer ✅✅250.102(C)(1) The NEC defines continuous load to be a load where max current on the circuit continues for at least how many hours? - answer ✅✅Three To use the adjustment factors in table 310.15(B)(3)(A), you must have greater than how many current carrying conductors in a raceway? - answer ✅✅Greater than three Where in the NEC codebook would you find EMT sizes for a given size and number of conductors? - answer ✅✅Annex C, Table C. Section 210.20(A) states that the over current protection for branch circuits including continuous loads must be greater than 100% of the noncontinuous plus ____ of the continuous load. - answer ✅✅125%
Liquidtight Flexible Metal Conduit shall be fastened within of each box or other conduit termination - answer ✅✅Twelve inches 314.28(A)(1) states that straight pulls in pull boxes with conductors size 4 AWG or larger, box length should be greater than or equal to times the trade diameter of the largest conduit entering box. - answer ✅✅Eight Chapter 9 note 4 states conduit nipples less than 24 inches can fill to a max of their cross sectional area - answer ✅✅60 percent Table 348.22 gives the max number of insulated conductors in size _______ FMC? - answer ✅✅3/8 (trade size) Guest rooms of hotels, motels, & sleeping rooms in dorms need a MIN or _____ general purpose receptacles installed that are readily accessible? - answer ✅✅Two When branch-circuit conductors are contained inside a ballast compartment and they are within 3 inches of the ballast, the conductors shall have a temperature rating of at LEAST _____. a) 105 degrees C b) 90 degrees C c) 75 degrees C d) 60 degrees C - answer ✅✅B: 90 degrees C Ref: 410. Class _____ locations are those that are hazardous because of the presence of easily ignitible fibers or materials producing combustible flyings. a) I b) II c) III d) IV - answer ✅✅C: III
Conductors installed in electrically heated floors in bathrooms, kitchens, and in hydro massage bathtub locations shall be provided with what kind of protection? - answer ✅✅GFCI 424.44(E) With 90 kVA and 208Y, what is the current on each ungrounded phase conductor at full load? - answer ✅✅90kVA/(208X1.732) 250 amps For dwelling units, GFCI protection shall be provided for lighting outlets not exceeding 120 volts where installed in - answer ✅✅Crawl spaces 430.32 gives percentages for marked service factors on motors. For 40 degrees C or less and 1.15, what is the percentage you multiply by? - answer ✅✅125% 422.13 states fixed storage water heaters with a capacity of ____ gallons should be considered a continuous load for sizing branch circuits - answer ✅✅120 gallons 250.54(G) states when driving a ground rod and solid rock is encountered, the ground rod is permitted to be buried in a trench at least how deep? - answer ✅✅30 inches Section 210.11(C)(2) states at least one additional _____ amp circuit shall be provided to supply the laundry outlet in the laundry room - answer ✅✅20 ampere What section of the NEC discusses corrosion protection? - answer ✅✅300. 300.6 says that where corrosion protection is necessary and the conduit is threaded in the field, the threads shall be coated with what? - answer ✅✅An electrically conductive, corrosion resistant compound 110.26 (E) discusses the space equal to the width and depth of the equipment and extending from the floor to a height of six feet above the equipment or to the structural ceiling. What is this called? - answer ✅✅Dedicated electrical space For single phase dwelling services, when sizing conductors, 100-400 amps, what do you multiply your ampacity by to derate? - answer ✅✅83 percent
For stationary motors of 2 hp or less, and 300 volts or less, a general use switch having an ampere rating of _____ the flc rating of the motor is permitted to be used - answer ✅✅2 times 240.22 states no over current device shall be connected in series with any conductors - answer ✅✅The overcurrent device opens all conductors of the circuit, including the grounded and is designed so no pole can operate independently. 314.72(E) states that a suitable cover to cover an underground box is considered to weigh what and shall have what written on it? - answer ✅✅100 pounds "Danger - High Voltage - Keep out" When an industrial control panel is supplied from a 3 phase, 4 wire, delta connected electrical system, the phase having the higher voltage to ground is labeled the - answer ✅✅"B" phase Where in the codebook would you find info about the minimum clearance for conductors passing over a public driveway? - answer ✅✅225.18(4) Outside branch circuits and feeders For Class 1 Divisions 1 and 2 locations, the conduit seal shall not exceed ____% fill of the cross sectional area - answer ✅✅25% Where in the code would you find information about conduit seals? - answer ✅✅Hazardous locations Table 300.5 shows what for different types of wiring methods or circuits based on the location? - answer ✅✅Minimum coverage requirements 0 to 1000 volts nominal burial in inches For show windows, atleast one 125 volt single phase 15 or 20 amp rated receptacle shall be installed within 18 inches from the top of the show window for every _____ feet of the horizontal window area? - answer ✅✅12 feet conductors supplying several motors, or a motor and other loads, shall have an ampacity equal or greater than the sum of what? - answer ✅✅125% flc of biggest motor + flc of all other motors + 100% of noncont non motor load + 125% of cont non motor load
For single phase services and feeders 100-400 amps on one family dwellings or individual dwellings, the conductors shall be permitted to have an ampacity not less than _____ percent of the service rating. - answer ✅✅83 percent Where the NEC specifies that one equipment should be "in sight from" "within sight from" or "within sight of" another equipment, it is to be visible and not more than how many feet? - answer ✅✅50 feet Mandatory rules of the NEC are those that identify actions that are specifically required or prohibited are characterized by the use of the terms: - answer ✅✅Shall or shall not Neon sign equipment having an open circuit voltage exceeding how many volts shall NOT be installed in or on dwelling occupancies? - answer ✅✅1000 volts Outlet definition NEC - answer ✅✅A point on the wiring system at which current is taken to supply utilization equipment Disregarding exceptions, the NEC mandates the MINIMUM size overhead service conductors to be - answer ✅✅8 AWG copper or 6 AWG aluminum Receptacles incorporating an isolated grounding conductor connection intended for the reduction of electrical noise, shall be identified by a/an_______located on the face of the receptacle - answer ✅✅red dot For the purpose of determining conductor fill in a device box, the NEC mandates a switch to be counted as equal to two (2) conductors. The volume allowance for the two (2) conductors. The volume allowance for the two conductors shall be based on the: - answer ✅✅Largest size wire in the box Where in the NEC codebook would you find information regarding Cables, Raceways, or Boxes installed in or Under Roof Decking? - answer ✅✅300.4(E) Which section of the NEC codebook contains conductors for general wiring charts? - answer ✅✅310.15(B)(16)
When calculating the branch circuit load for a counter mounted cooking unit and not more than two wall mounted ovens that are supplied from a single branch circuit and located in the same room, 220. note 4 states that you can do what? - answer ✅✅Add the two nameplate ratings and treat it as one range When sizing type NM cable conductors in 220.15(B)(16), what temperature rating column do you always use? - answer ✅✅60 degrees celsius Direct and alternating current differ in that alternating current - answer ✅✅reverses at intervals Luminaires containing a metal halide lamp (other than a thick glass PAR lamp) shall be provided with a containment barrier that encloses the lamp, or shall be provided with a containment barrier that encloses the lamp, or shall be provided with a physical means that only allow the use of a - answer ✅✅lamp that is type O The ampacity adjustment factors for conductors in section 310.15(B)(3)(a) of the NEC are not required to be applied when the conductors are installed in a metal wireway unless the number of current carrying conductors within the wireway exceeds - answer ✅✅ 30 Ceiling suspended (paddle) fans weighing MORE than ____ pounds shall be supported independently of the outlet box - answer ✅✅70 pounds The connection between the grounded circuit conductor and the equipment grounding conductors at the electrical service is recognized as the _____ in the NEC - answer ✅✅main bonding jumper The NEC requires an equipment bonding jumper to be - answer ✅✅continuous When determining the number of 120V, 15 amp 2wire lighting branch circuits required for a residence 70ft by 30ft, you multiply by 3 va/square foot and then what? - answer ✅✅Divide that number by 120, then the size of the branch circuit (15 amps) In the electric space heating equipment section of the NEC, resistance type heating elements in electric space heating equipment shall be subdivided into loads NOT exceeding - answer ✅✅48 amperes