1
/
4
NTN Fireteam Study Set Q&A
1. What do you use to tighten a bolt:
socket
wrench
2.
What shape is a drillbit used for metal: sleek shape, not pointed, no pertruding edges for
operations at high speed to go through hard metal
or sometimes wood
3.
what shape drillbit is hand operated for drilling wood:
the tip is a threaded point,
pertruding edges to cut through soft wood.
4. what shape drillbit is used from ceramics/masonry:
squared ott tip bit
5. small gear vs big gear, what turns faster?: Big gear
6. When installing Bolt w/ washer and nut, what side faces you?: Threaded end goes
away from body to prevent hazard
7.
What tool is used to cut bolts?: Hacksaw (NOT
BOLTCUTTERS)
8. Mechanical Brick Factory: What do you do if there is unmelted material?:
Stop,
call mechanic
9. Mechanical Brick Factory: If you want more material from the start of the
assembly, what do you do?: Adjust
amount released by Hopper, DONT adjust speed of belt
10. Mechanical Brick Factory: If the first grinder is stuck, what do you suspect?-
:
There
is
a
jam
in
the
grinder
11.
Mechanical Brick Factory: How do you fix a grinder jam?:
You put it in reverse
manually
12. Mechanical Brick Factory: How do you remove a molding station arm?:
1. Loosen
middle nut
2.
then
remove
end
nut
13. Mechanical Brick Factory: If water is pouring over the edge, what do you
suspect is wrong?: Green
