Study with the several resources on Docsity
Earn points by helping other students or get them with a premium plan
Prepare for your exams
Study with the several resources on Docsity
Earn points to download
Earn points by helping other students or get them with a premium plan
A sieve analysis (or gradation test) is a practice or procedure used (commonly used in Civil Engineering) to assess the particle.
Typology: Exercises
1 / 9
This page cannot be seen from the preview
Don't miss anything!
Technology of Material II TKS 4012 Prepared by [email protected]
A sieve analysis (or gradation test ) is a practice or procedure used (commonly used in Civil Engineering ) to assess the particle
granular material. The size distribution is often of critical importance to the way the material performs in use.
Introduction (contโd) A sieve analysis can be performed on any type of non-organic or organic granular materials including sands, crushed rock, clays, granite, feldspars, coal, soil, a wide range of manufactured powders, grain and seeds, down to a minimum size depending on the exact method. Being such a simple technique of particle sizing, it is probably the most common used in practice. Tools and Equipment A sieve , or sifter (the word "sift" derives from 'sieveโ), is a device for characterizing the particle size distribution of a sample, typically using a woven screen such as a mesh or net.
Procedure (contโd) A suitable sieve size for the aggregate should be selected and placed in order of decreasing size, from top to bottom, in a mechanical sieve shaker. A pan should be placed underneath the nest of sieves to collect the aggregate that passes through the smallest. Procedure (contโd) The entire nest is then agitated, and the material whose diameter is smaller than the mesh opening pass through the sieves. After the aggregate reaches the pan, the amount of material retained in each sieve is then weighed.
Results To find the percent of aggregate passing through each sieve, first find the percent retained in each sieve. To do so, the following equation is used: %๐น๐๐๐๐๐๐๐ = ๐พ๐บ๐๐๐๐ ๐พ๐ป๐๐๐๐
where WSieve is the weight of aggregate in the sieve and WTotal is the total weight of the aggregate. Results (contโd) The next step is to find the cumulative percent of aggregate retained in each sieve. To do so, add up the total amount of aggregate that is retained in each sieve and the amount in the previous sieves. The cumulative percent passing of the aggregate ( % CP ) is found by subtracting the percent cumulative retained ( % CR ) from 100 %. %๐ช๐ท = ๐๐๐% โ %๐ช๐น
Types of Gradation (contโd)
1. Dense gradation , refers to a sample that is approximately of equal amounts of various sizes of aggregate. By having a dense gradation, most of the air voids between the material are filled with particles. A dense gradation will result in an even curve on the gradation graph. 2. Narrow gradation , also known as uniform gradation, a narrow gradation is a sample that has aggregate of approximately the same size. The curve on the gradation graph is very steep, and occupies a small range of the aggregate. **Types of Gradation (contโd)
Types of Gradation (contโd)
5. Rich gradation , refers to a sample of aggregate with a high proportion of particles of small sizes. Fineness Modulus The Fineness Modulus (FM) is an index number which is roughly proportional to the average size of the particles in an aggregate sample. It is obtained by adding the cumulative percentages coarser than each of the standard sieves used for segregating sand and dividing the cumulative percentage by 100.
