Cisco Certification Exam 1 Q & A.
Which technology supports the stateless assignment of IPv6 addresses? - Correct
Answer autoconfiguration
What are two requirements for an HSRP group? - Correct Answer exactly one active
router (and) exactly one standby active router
After you configure the Loopback0 interface, which command can you enter to verify the
status of the interface and determine whether fast switching is enabled? - Correct
Answer Router#show ip interface loopback 0
Which command sequence can you enter to create VLAN 20 and assign it to an
interface on a switch? - Correct Answer Switch(config)#vlan 20 (*THEN*)
Switch(config)#Interface gig x/y (*THEN*)
Switch(config-if)#switchport access vlan 20
Which three commands can you use to set a router boot image? - Correct Answer
Router(config)# boot system flash c4500-p-mz.121-20.bin (*THEN*)
Router(config)# boot system tftp c7300-js-mz.122-33.SB8a.bin (*THEN*)
Router(config)#boot system rom c7301-advipservicesk9-mz.124-24.T4.bin
Which two statements about IPv6 and routing protocols are true? - Correct Answer Link-
local addresses are used to form routing adjacencies (and)
OSPFv3 was developed to support IPv6 routing
If primary and secondary root switches with priority 16384 both experience catastrophic
losses, which tertiary switch can take over? - Correct Answer a switch with priority
20480
Which two statements about late collisions are true? - Correct Answer They may
indicate a duplex mismatch (and) By definition, they occur after the 512th bit of the
frame has been transmitted
Which command can you enter to set the default route for all traffic to an interface? -
Correct Answer router(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1
Which two spanning-tree port states does RSTP combine to allow faster convergence?
- Correct Answer blocking (and) listening
