Switch>en
Switch>enable
Switch#con
Switch#conf
Switch#configure termina
Switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#host
Switch(config)#host sw
Switch(config)#host swUTM1
swUTM1(config)#vlan 60
swUTM1(config-vlan)#name vicerrectorado
swUTM1(config-vlan)#exit
swUTM1(config)#vlan 50
swUTM1(config-vlan)#name financiero
swUTM1(config-vlan)#exit
swUTM1(config)#vlan 70
swUTM1(config-vlan)#name direccion-de-tic
swUTM1(config-vlan)#exit
swUTM1(config)#inte
swUTM1(config)#interface ran
swUTM1(config)#interface range fa
swUTM1(config)#interface range fastEthernet 0/1-2
swUTM1(config-if-range)#swi
swUTM1(config-if-range)#switchport mode ac
swUTM1(config-if-range)#switchport mode access
swUTM1(config-if-range)#sw
swUTM1(config-if-range)#switchport acc
swUTM1(config-if-range)#switchport access vlan 60
swUTM1(config-if-range)#exit
swUTM1(config)#interface range fastEthernet 0/3-4
swUTM1(config-if-range)#switchport mode access
swUTM1(config-if-range)#switchport access vlan 50
swUTM1(config-if-range)#exit
swUTM1(config)#interface range fastEthernet 0/5-6
swUTM1(config-if-range)#switchport mode access
swUTM1(config-if-range)#switchport access vlan 70
swUTM1(config-if-range)#exit
swUTM1(config)#inter
swUTM1(config)#interface gi
swUTM1(config)#interface gigabitEthernet 0/1
swUTM1(config-if)#swi
swUTM1(config-if)#switchport mode trun
swUTM1(config-if)#switchport mode trunk
swUTM1(config-if)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed
state to down
